An analysis of risk factors for venous thromboembolism in primary versus revision total joint arthroplasty.

Background: One of the most serious complications after primary or revision lower extremity total joint arthroplasty (TJA) is venous thromboembolism disease (VTE). Identifying patients at high risk for VTE allows tailoring of prophylactic anticoagulation regimens to those most vulnerable. This study aimed to identify risk factors for VTE in primary and revision lower extremity TJA. Methods: The Electronic Medical Record was queried from a single academic institution for all patients who underwent a lower extremity TJA between 2007 and 2020. Demographics, comorbid conditions, perioperative characteristics, and postoperative complications were identified. An Elastic Net Multiple Logistic Regression Model was used to assess 49 covariates and predict those associated with a significant risk of VTE. Results: We identified 4900 primary and revision total knee arthroplasty (TKA) and total hip arthroplasty (THA) patients. There was no significant difference between primary and revision THA. Primary TKA had a higher rate of VTE than revision TKA. Significant risk factors identified for VTE in THA patients include histories of deep vein thrombosis (DVT), pulmonary embolism (PE), metastatic tumors, hemiplegia, and Hispanic ethnicity. Risk factors for VTE in TKA patients include histories of DVT, PE, metastatic tumors, and postoperative warfarin and heparin use. In all patients, age was a significant predictor of VTE risk. Conclusion: Our work identifies many risk factors for VTE following TJA. While the increased rate of VTE in some populations may represent selection bias, it also highlights the incomplete understanding of the etiology and prevention of this complication in the joint arthroplasty population and requires further study.

Femoral Component Fracture in a Total Knee Arthroplasty Patient With a Persistent Flexion Contracture.

This article reports a rare case of a total knee arthroplasty femoral component fracture. Fractures of early knee systems were attributed to design flaws. Modern design failures have been attributed to poor surgical technique or underlying osteolysis. Here, we report a fracture in the Vanguard prosthesis (Zimmer Biomet, Warsaw, IN) 12 years after implantation in a patient with a persistent flexion contracture. The fracture likely occurred due to fatigue failure of the anterior flange secondary to increased stress from a high riding patella. Although femoral component fractures are rare, they should be considered as a potential complication, especially in patients with special load considerations. For these patients, it is essential that the prosthesis be properly supported with clean cuts and an adequate cement mantle.